MussBrew
Active Member
I have an adjustable industrial shelf that sits on top of a dolly with the measurements of 24"x24"x60" for my single tier stand. On each side I have two burners and in the middle a cooler mash tun. I would like to hard plumb a gas line to both burners and an optional 3rd in for the middle for down the road when/if i get a third burner. My plan is to use 1/2" piping to run along the length of the stand with 3 "T" junctions for each spot with a cap on the end of the main line. Connected to each "T" junction will be 1/2" gas ball valves followed by an 1/2" to 5/8" adapter where an adjustable gas flex line will connect to each burner. The problems I'm facing are as follows....
1) I have one burner which is a metal fusion burner with a 1/4" inlet and a blichmann burner with a 5/8" inlet (I believe....) . What fittings should I use to connect each burner to the gas flex line?
2) The blichmann burner comes with a 10 psi regulator with a 5/8" attachment and my metal fusion burner has i believe a 30 psi regulator with a 1/4" attachment. Which regulator or what other options could i use that would allow both burners to work at the best efficiencies when they both need different psi's ? My plan was to connect one of the two regulators from the main gas line to the propane tank...
Down below i have pics of my set up. Any thoughts how to make this all work?
1) I have one burner which is a metal fusion burner with a 1/4" inlet and a blichmann burner with a 5/8" inlet (I believe....) . What fittings should I use to connect each burner to the gas flex line?
2) The blichmann burner comes with a 10 psi regulator with a 5/8" attachment and my metal fusion burner has i believe a 30 psi regulator with a 1/4" attachment. Which regulator or what other options could i use that would allow both burners to work at the best efficiencies when they both need different psi's ? My plan was to connect one of the two regulators from the main gas line to the propane tank...
Down below i have pics of my set up. Any thoughts how to make this all work?