Drake371
Member
I am designing a HERMS system to be fully automated by a BrewTroller board with 2 MUX boards (1 for driving the solenoid valves and one for the SSR for the heating element and pump) More information about the BrewTroller can be found here.
In any case I was wondering if I could get a few of you peeps to look over my flow diagram for my HERMS system, just checking to make sure I didn't miss anything. (if the pic doesn't show up, it can be found here.
Thanks for your time,
drake
In any case I was wondering if I could get a few of you peeps to look over my flow diagram for my HERMS system, just checking to make sure I didn't miss anything. (if the pic doesn't show up, it can be found here.
Thanks for your time,
drake