Jjk
New Member
First of all I wanted to thank everyone in the forum for all of the great advice given to others. Every time I have had a question a search has revealed the exact answer I was looking for. So I'm sure my question has been answered already but I just haven't been able to find it.
After bottling a few batches I decided to take the plunge and purchased a keg kit with all of the trimmings. I kegged my first 2 batches last night and everything went pretty smoothly. I checked on them this morning and my CO2 canister was empty. Went ahead and found the leak on my 4 way splitter. I wasn't able to get it tight no matter how hard I tried. The question is... until my replacement arrives how long will my beer hold? If there are no leaks on the kegs and they are pressurized will they be fine? I was using the set and forget method and have them stored at 50 degrees.
Thanks.
After bottling a few batches I decided to take the plunge and purchased a keg kit with all of the trimmings. I kegged my first 2 batches last night and everything went pretty smoothly. I checked on them this morning and my CO2 canister was empty. Went ahead and found the leak on my 4 way splitter. I wasn't able to get it tight no matter how hard I tried. The question is... until my replacement arrives how long will my beer hold? If there are no leaks on the kegs and they are pressurized will they be fine? I was using the set and forget method and have them stored at 50 degrees.
Thanks.