dWiGhT-TX
Member
I was looking at doing a gas beam on the system I am planning on building. I notice that Brutus10 uses a low pressure system (1-2psi?)... I was planning on using the ring burners on mine and using a 20-30psi regulator.
I'm using 1/16" (16 gauge) stainless steel for the frame... I don't have a way to calculate the stress involved but figure since the cornies I have take 130psi and are way thinner that as long as the welds are high quality TIG welds I won't have any problems.
Anyone else use this setup for their system???
dWiGhT
I'm using 1/16" (16 gauge) stainless steel for the frame... I don't have a way to calculate the stress involved but figure since the cornies I have take 130psi and are way thinner that as long as the welds are high quality TIG welds I won't have any problems.
Anyone else use this setup for their system???
dWiGhT