rockinmarty
Big Member
Has anyone tried this pid
http://www.ebay.ca/itm/PID-Digital-...402?pt=LH_DefaultDomain_0&hash=item4d03e80e1a
http://www.ebay.ca/itm/PID-Digital-...402?pt=LH_DefaultDomain_0&hash=item4d03e80e1a
The MyPins work OK but they're much more difficult to program and don't have a manual mode to control boils.
Good point. I have a PWM on my system for boiling, so I always forget about the manual boil mode in these discussions.
I too, have a TA6 and I'm having problems with the programing and of course, there is no help from the company that sold it or the manufacturer.
I have been able to wire it correctly, and set a heating temp. When checking to see if it's working, I am using a light buld instead of a heating element.
when it is heating towards the required temp, the light stays on. But, within 10* of the target temp, the light bulb begins to flash untill it reaches temp and then shuts off.
I realize that if the bulb is flashing on and off, then the current would be doing the same to a heating element, and worse, it will cause premature failure to the solid state relay.
Can somone please tell me where I am going wrong???
Thanks in advance,
Brian
916-804-0175
I too, have a TA6 and I'm having problems with the programing and of course, there is no help from the company that sold it or the manufacturer.
I have 2 of the MyPin TA6 Pids that come with the type K and the 25A SSR, they've been working OK ...as I recall the package was $35
Enter your email address to join: