Fingers
Well-Known Member
So I've decided to build my own tower to match the bar its going on. I have two taps right now and I'll eventually get up to six. The frame will be steel to support the stress of pulling on taps and it will be wrapped in wood to match the bar.
I need to pre-drill the steel for six taps but drill the outside wood for only two right now. I need to know how far apart is optimal for spacing the taps and how high they should be. Please post comments and advice based on your own experiences.
I know Brewpastor built a nice little unit so I'm hoping he'll pipe up and share his knowledge...
I need to pre-drill the steel for six taps but drill the outside wood for only two right now. I need to know how far apart is optimal for spacing the taps and how high they should be. Please post comments and advice based on your own experiences.
I know Brewpastor built a nice little unit so I'm hoping he'll pipe up and share his knowledge...