Elfmaze
Well-Known Member
When i had the welding done on my keggle the plugs got fused into the couplings. Oil and big wrenches later i got the three plugs out. two of the couplings i was able to get to seal up again the thermometer and the ball valve, BUT the sight glass port is too damaged. I tried taping and lubing a SS plug into the port and got it all the way in, BUT it was still dripping and when i took it out the first three rows of threads on the plug were flattened . When i get the site glass fittings in do i force them in again and see if i can get it to seal with lots of tape, or is it to the point were its time to solder around the joint?