Beernik
Well-Known Member
It is finally done, and holds water.
I'm thinking about making some more modifications to the lauter manifold. I'm thinking I'll add some crosses and tees and put in two more sideways pipes. I'm also thinking of shortening the width so that I'm less likely to channel water down the cooler wall.
Top view
Side view
That's a digital themometer probe and a racking cane that enter the side. The racking cane is there so I can see where the surface elevation of the mash.
Front view
Sparge manifold
Lauter Manifold
Lauter Manifold
I'm thinking about making some more modifications to the lauter manifold. I'm thinking I'll add some crosses and tees and put in two more sideways pipes. I'm also thinking of shortening the width so that I'm less likely to channel water down the cooler wall.
Top view
Side view
That's a digital themometer probe and a racking cane that enter the side. The racking cane is there so I can see where the surface elevation of the mash.
Front view
Sparge manifold
Lauter Manifold
Lauter Manifold