Afternoon All,
Driving by a garage sale and saw an old beat up keg; gave them $10 for it. I'd like to have it retro-fitted with all the Cornelius Keg attachments. I would like to know if any of you have had anything like this done and if SABCO is my best bet. I can only MIG-weld and do that as a dirt dauber builds a nest so I'm clearly out of my league even if I rented a TIG welder. Around Austin, TX I have yet to fine anyone capable of welding stainless properly. I rolled into one place and the guy said sure I could cut that and weld this here and that there, etc.; however, when I inspected his equipment he just had an arc-welder and I got very hesitant. Any advice would greatly appreciated. If you've successfully had this done or know of anyone to do this in my area I'd like to hear from you. If all else I can turn it into a kettle I guess. Thanks, Jeffrey
Driving by a garage sale and saw an old beat up keg; gave them $10 for it. I'd like to have it retro-fitted with all the Cornelius Keg attachments. I would like to know if any of you have had anything like this done and if SABCO is my best bet. I can only MIG-weld and do that as a dirt dauber builds a nest so I'm clearly out of my league even if I rented a TIG welder. Around Austin, TX I have yet to fine anyone capable of welding stainless properly. I rolled into one place and the guy said sure I could cut that and weld this here and that there, etc.; however, when I inspected his equipment he just had an arc-welder and I got very hesitant. Any advice would greatly appreciated. If you've successfully had this done or know of anyone to do this in my area I'd like to hear from you. If all else I can turn it into a kettle I guess. Thanks, Jeffrey