Jekster
Well-Known Member
I was playing around with my kegging gear tonight after getting my co2 tank filled. I didn't go in depth, but wanted to see if I could just hand tighten on the regulator and get a seal. It didn't come even close and just spewed co2 whenever I opened up the tank. So, my questions is: Do you have to go to town with a wrench to get these things to seal, or was I just not using enough elbow grease and Teflon tape? I ask because I found when sealing the ball valves on my kettle and mash tun that tighter is not always better. Also, should there be any type of gasket on my regulator? Because it doesn't have one at all and I'm wondering how it's supposed to seal without any type of gasket.
Thanks as always,
-Jek
Thanks as always,
-Jek