sublimnl
Well-Known Member
Hi all, I just made my first brew last night - I got the 1 gallon kit from Brooklyn Brew Shop and it came with the all grain A Well Made Triple mix.
Everything went pretty smoothly (after confirming the instructions and getting improvements/clarifications from a friend who has been brewing for a while). So this morning I saw the sanitized water bubbling and everything looked great.
Now, a little over 12 hours later, I come home and did a quick peek and notice the water is still bubbling, however in a place where the rubber tube was bent in the packaging there is some foam built up. I notice traces of foam else where in the tube but it's very minor and seems like it would be OK - but in this crease it's built up enough that it has me concerned that it will dry and clog the blow tube.
Is this a legitimate concern or can I safely ignore it?
Thanks!
Everything went pretty smoothly (after confirming the instructions and getting improvements/clarifications from a friend who has been brewing for a while). So this morning I saw the sanitized water bubbling and everything looked great.
Now, a little over 12 hours later, I come home and did a quick peek and notice the water is still bubbling, however in a place where the rubber tube was bent in the packaging there is some foam built up. I notice traces of foam else where in the tube but it's very minor and seems like it would be OK - but in this crease it's built up enough that it has me concerned that it will dry and clog the blow tube.
Is this a legitimate concern or can I safely ignore it?
Thanks!