I am sure this has been beat on like a dead horse, but hey Im new here. LOL
I am going to start slowly building a nice 10 gal brewery and decided to start with the mash tun. I picked up a couple of 15 gal kegs for 50 bucks each and I have already cut the top out of one of them with my plasma cutter.
From all the posts that I am reading I will probably build a rims. So should I run the drain out of the bottom? It would seem that I would get all the wort out that way. I picked up some weld bungs on ebay but I still need to figure out what kind of valves. Lots of options.
I am going to start slowly building a nice 10 gal brewery and decided to start with the mash tun. I picked up a couple of 15 gal kegs for 50 bucks each and I have already cut the top out of one of them with my plasma cutter.
From all the posts that I am reading I will probably build a rims. So should I run the drain out of the bottom? It would seem that I would get all the wort out that way. I picked up some weld bungs on ebay but I still need to figure out what kind of valves. Lots of options.