DubbelDach
Well-Known Member
So using this: Build Your Own Stir Plate as a guide... I started acquiring parts.
Got an 80mm multi-speed fan with sweet green LEDs, a black hard drive case with power switch incorporated, and two 25mm stir bars. Also salvaged two rare earth magnets from a hard drive set to be scrapped at work.
So.... I have limited electrical knowledge (read: none). Inside the case is a small board, and I'm wondering if it would be better to just splice the fan onto a cell charger and rig a different switch. There's no input on the board for the 3-hole plug on the fan (BYO article said to get a case with that, but me = fail). Anybody see anyway this can get hooked up?
Here's the fan switch:
Rest of pics here, if they help... http://s281.photobucket.com/albums/kk238/shiplax27/Stir_Plate/ Thanks in advance!
Got an 80mm multi-speed fan with sweet green LEDs, a black hard drive case with power switch incorporated, and two 25mm stir bars. Also salvaged two rare earth magnets from a hard drive set to be scrapped at work.
So.... I have limited electrical knowledge (read: none). Inside the case is a small board, and I'm wondering if it would be better to just splice the fan onto a cell charger and rig a different switch. There's no input on the board for the 3-hole plug on the fan (BYO article said to get a case with that, but me = fail). Anybody see anyway this can get hooked up?
Here's the fan switch:
Rest of pics here, if they help... http://s281.photobucket.com/albums/kk238/shiplax27/Stir_Plate/ Thanks in advance!