Kayos
Well-Known Member
Been reading all the great info on going AG tonight....
Couple of questions...
1. Why does the cooler have to be 10 gallons if I am doing 5 gallon batches?
2. Why is everyone buying 2 of these (do I need a seperate mt and lt?)? Is it for rests? Why do you need rests?
3. Do I need a hot liquor tank? Why can't I just use my brew kettle?
4. How do I figure out the efficiency after brewing?
5. How do I figure out how much water to use with the grain, then how much with the batch sparge?
6. Do you still steep specialty grains or put then in with the base grain?
I saw an earlier post where a guy was using a 5g cooler and a similar homemade setup, put in 160 degree water held for an hour, then let it run into the brewpot. Then soak (sparge) the grain with 170, recycle that water a few times, then into the brewpot. What does the second cooler do? Thanks!!!
Couple of questions...
1. Why does the cooler have to be 10 gallons if I am doing 5 gallon batches?
2. Why is everyone buying 2 of these (do I need a seperate mt and lt?)? Is it for rests? Why do you need rests?
3. Do I need a hot liquor tank? Why can't I just use my brew kettle?
4. How do I figure out the efficiency after brewing?
5. How do I figure out how much water to use with the grain, then how much with the batch sparge?
6. Do you still steep specialty grains or put then in with the base grain?
I saw an earlier post where a guy was using a 5g cooler and a similar homemade setup, put in 160 degree water held for an hour, then let it run into the brewpot. Then soak (sparge) the grain with 170, recycle that water a few times, then into the brewpot. What does the second cooler do? Thanks!!!