- Joined
- Feb 11, 2010
- Messages
- 149
- Reaction score
- 0
Well, this post falls into both the equipment and sanitation categories. I just got a Ferrari brand "Avvinatore" in the mail. The unit came disassembled and the instructions are somewhat lacking. There is an exploded diagram on flap of the box, but it doesn't really provide much detail on assembly instructions. I put it together as intuition would state, but I have one piece left over and it's currently not working the way it is (nothing sprays out of the nozzle). I'm hoping someone with the same or similar vinator can help me out.
The piece i have left over is a small plastic screen about 0.5" in diameter.
I assembled in this order:
1. Clear plastic bowl
2. Orange insert into bowl lining up the three tabs with the three notches on the bowl.
3. Skinny white piece (the nozzle that pushes down) into hole of fatter white piece with threads on the bottom.
4. Stuck spring inside thin white piece (it protrudes from the bottom of the fat white piece).
5. Compressed spring centered on orange insert and screwed fat white piece into orange insert.
I filled it about half way up with water and there doesn't seem to be any suction/spray action going on at all when I push down on the nozzle.
Thanks in advance for the help!
The piece i have left over is a small plastic screen about 0.5" in diameter.
I assembled in this order:
1. Clear plastic bowl
2. Orange insert into bowl lining up the three tabs with the three notches on the bowl.
3. Skinny white piece (the nozzle that pushes down) into hole of fatter white piece with threads on the bottom.
4. Stuck spring inside thin white piece (it protrudes from the bottom of the fat white piece).
5. Compressed spring centered on orange insert and screwed fat white piece into orange insert.
I filled it about half way up with water and there doesn't seem to be any suction/spray action going on at all when I push down on the nozzle.
Thanks in advance for the help!