I'm building a kegerator, and have most of the parts already, but I still need to buy tubing. The only thing is the barbs in the different parts all have different diameters. I've never worked with PVC tubing, so I don't know what kind of tolerances they have, so I'm not sure what diameter tubing to go for, or if I'll need any additional adapters.
This is what I have so far:
(Diameter has been measured with a digital calipers at the widest part of the barb)
Disconnects (Gas and Beer): 0.277"
Regulator: 0.356"
Gas Manifold (CO2 tank side): 0.297"
Gas Manifold (Keg side): 0.354"
Taps: 0.307"
Any help would be appreciated. Thanks
This is what I have so far:
(Diameter has been measured with a digital calipers at the widest part of the barb)
Disconnects (Gas and Beer): 0.277"
Regulator: 0.356"
Gas Manifold (CO2 tank side): 0.297"
Gas Manifold (Keg side): 0.354"
Taps: 0.307"
Any help would be appreciated. Thanks