The Pol
Well-Known Member
- Joined
- Feb 12, 2007
- Messages
- 11,390
- Reaction score
- 118
Well, here is the "idea"...
Utilize (2) march pumps
(1) Therminator
(1) 10 gallons of ICE water
During the boil I clean my MLT.
Refill MLT with water and (3) gallons of ICE
After boil is complete operate ONE pump to recirc boiling wort through THERMINATOR back to the kettle to help sanitize therminator.
To chill, run both pumps at full flow. One to recirc ice water from MLT to the chiller and back to the MLT. The other pump will recirc the wort through the Therminator to the kettle through a QD fitting on the side of the kettle that is attached to a length of LocLine on the INside of the BK.
The PID thermocouple in the BK would monitor temp.
Would this work? I am looking to spend some money is all, is this an effective way to spend money?
Utilize (2) march pumps
(1) Therminator
(1) 10 gallons of ICE water
During the boil I clean my MLT.
Refill MLT with water and (3) gallons of ICE
After boil is complete operate ONE pump to recirc boiling wort through THERMINATOR back to the kettle to help sanitize therminator.
To chill, run both pumps at full flow. One to recirc ice water from MLT to the chiller and back to the MLT. The other pump will recirc the wort through the Therminator to the kettle through a QD fitting on the side of the kettle that is attached to a length of LocLine on the INside of the BK.
The PID thermocouple in the BK would monitor temp.
Would this work? I am looking to spend some money is all, is this an effective way to spend money?