I did my first all grain this last weekend and everything went fairly smoothly. I did come up short on my gravity a bit. I didn't take the reading until after the boil. If you check it before the boil will it be the same?
I have some dme on hand and was going to add that, but since I didn't know about it till after the boil I just let it go. It wasn't too low. My question is What is the procedure for checking gravity and adding some extract if you want to compensate?
Can anyone give a short answer to how you check efficiency?
Thanks
I have some dme on hand and was going to add that, but since I didn't know about it till after the boil I just let it go. It wasn't too low. My question is What is the procedure for checking gravity and adding some extract if you want to compensate?
Can anyone give a short answer to how you check efficiency?
Thanks