My control panel is runs on a 12 volt control system to fire the contactors and SSRs. My problem is I looking at have a different color LED (or lamp) lit for each control (manual or BCS) So I running a DPDT ON-OFF-ON switch.
The problem is since the BCS control is only 5 volts I'm having a hard time finding a lamp to light on the control circuit going to the SSRs.
Manual Mode is fine as I run a 12 volt lead directly from the terminal block to switch.
Has anyone seen used a seperate component or lamp in a similar fashion?
Any ideas?
The problem is since the BCS control is only 5 volts I'm having a hard time finding a lamp to light on the control circuit going to the SSRs.
Manual Mode is fine as I run a 12 volt lead directly from the terminal block to switch.
Has anyone seen used a seperate component or lamp in a similar fashion?
Any ideas?