Brewer Gerard
Well-Known Member
I'm in the middle of putting a design together for an eHerms brewery. Think I'm gonna go down the route of using some asco solenoid valves to control the flow from tank to tank. Anyway, the intention is to use some 0.5 inch (internal diameter) silicon tubing to transfer the hot liquid/wort from vessel to vessel. In terms the pipe size specification for the valves what would match 0.5 inch tubing. I don't want the valve to restrict flow in any way. I already picked up a cheap one on ebay that has a pipe size of G1/4 but this too small!
If anybody could recommend the right size hose barb to screw into such a valve that would also be helpful!
If anybody could recommend the right size hose barb to screw into such a valve that would also be helpful!