Mrakis
Well-Known Member
So i just purchased the 10 gallon boilermaker and did my first all grain batch yesterday. I made my purchase knowing that the thermometer sits a little to high. Basically it rests at about the 4 gallon mark. When i was heating up my strike water the thermometer was basically pointless, because i was heating just a little over 4 gallons of water. Therefore, the thermometer was barely submerged and not giving me accurate readings.
These boards have helped me greatly with work arounds in all other areas of homebrewing. I was wondering if anyone had a creative way to work around this short coming. It would be nice if there was some way to make an extension for the thermometer so that you could angle it down towards the water.
These boards have helped me greatly with work arounds in all other areas of homebrewing. I was wondering if anyone had a creative way to work around this short coming. It would be nice if there was some way to make an extension for the thermometer so that you could angle it down towards the water.