Looking to flip my rubberized Keg upside down and use it as a bottom drain HLT. I've seen a Sanke-to-Tri-Clover adapter in person, but have not been able to find where to find the stuff to do this.
I'm looking to go with 1/2 threaded and go 90 degrees on the Tri-clover.
Is there an adapter? Or how does it fit into the sanke port? I have the Dip tubes from my kegs, and may only need to buy new locking rings to hold them in place.
This setup would allow me to do bottom drain without removing the rubber. (Still have to do a small section on the side for the Electric element, but that's ok)
I'm looking to go with 1/2 threaded and go 90 degrees on the Tri-clover.
Is there an adapter? Or how does it fit into the sanke port? I have the Dip tubes from my kegs, and may only need to buy new locking rings to hold them in place.
This setup would allow me to do bottom drain without removing the rubber. (Still have to do a small section on the side for the Electric element, but that's ok)