brooklanebrewing
Well-Known Member
First off, Thanks to so many great posters and the wealth of information sharing that goes on around here.
My build is essentially based off of the electric brewery's website and P-J's wiring diagrams. I found a great 80qt kettle with a steamer bottom on ebay for $125 shipped. the steamer bottom has about a 3.5" gap below it that will keep the grain bag off the drain, whirlpool inlet, rtd/ sightglass, and element. Everything else has just been ordered and i will hopefully be brewing on the thing by december. So far i've just received the kettle and have pics below.
I do have a wiring question regarding my 50a gfci. basically, i will be running a polycarbonate enclosure and i was wondering what anyone thinks about cutting my breaker right into my control box. This way, i don't need another enclosure and extra plugs. my disconnect then, would be right on my control box so i could just unplug my brewstand from my second dryer outlet and move it into storage.
Thanks,
monk e
My build is essentially based off of the electric brewery's website and P-J's wiring diagrams. I found a great 80qt kettle with a steamer bottom on ebay for $125 shipped. the steamer bottom has about a 3.5" gap below it that will keep the grain bag off the drain, whirlpool inlet, rtd/ sightglass, and element. Everything else has just been ordered and i will hopefully be brewing on the thing by december. So far i've just received the kettle and have pics below.
I do have a wiring question regarding my 50a gfci. basically, i will be running a polycarbonate enclosure and i was wondering what anyone thinks about cutting my breaker right into my control box. This way, i don't need another enclosure and extra plugs. my disconnect then, would be right on my control box so i could just unplug my brewstand from my second dryer outlet and move it into storage.
Thanks,
monk e