Hi guys and gals - I posted this under the brutus tread but I figured other ppl have experience with the plastic quick disconnects outside of that thread.
So last night I basically finished up my brutus ten (it was a long project) and I noticed that my plastic quick disconnects are straight through (no internal valve that prohibits fluids to pass once disconnected). This seems like it would cause a very messy brew day.
Does anyone have experience with the plastic disconnects without an internal valve? Do they make it a pain in the ass with excess spilling every time you disconnect your valves? I foresee wort getting all over my stand, pumps, and floor when using these.
I am thinking of returning them and getting the disconnects with the valves but want a second opinion before I do.
Thanks in advance,
cmp
So last night I basically finished up my brutus ten (it was a long project) and I noticed that my plastic quick disconnects are straight through (no internal valve that prohibits fluids to pass once disconnected). This seems like it would cause a very messy brew day.
Does anyone have experience with the plastic disconnects without an internal valve? Do they make it a pain in the ass with excess spilling every time you disconnect your valves? I foresee wort getting all over my stand, pumps, and floor when using these.
I am thinking of returning them and getting the disconnects with the valves but want a second opinion before I do.
Thanks in advance,
cmp