tone_s
Member
Got to clean and sanitize but it flows very well. I drilled holes on the bottom instead of cutting slits. Have to try with grains and see if it gets stuck. Got extra pipe if it does and I go with slits.
CPVC Manifold build for my Igloo MLT
- Thread starter tone_s
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
MidTNJasonF
Well-Known Member
Holes look way big. I think I drilled mine 3/32". I get nice clear wort with very little if any recirculation and I have had one stuck mash in dozens of brews. Stuck mash was a wheat heavy malt bill with a fine crush.
OP
OP
tone_s
Member
Yep. I drilled them too big. I have extra pipe.
Lesson learned the hard way. I should have thoroughly read everyone's articles.
Good thing CPVC is so cheap. Used a leftover bag of grain from an old kit to test, so no loss there either.
Lesson learned the hard way. I should have thoroughly read everyone's articles.
Good thing CPVC is so cheap. Used a leftover bag of grain from an old kit to test, so no loss there either.
Similar threads
