bosdave
Well-Known Member
Hey all,
Not sure if this is the correct forum, but here it goes.
I have a Sanke keg that I would like to convert to a mash tun w/ RIMS.
I was curious if anyone in Denver/Boulder/Ft Collins/Springs is capable of doing this? Or, if you have had it done, where did you go? What was/would be the cost of doing this?
The closer to Boulder the better!
TIA
Dave
Not sure if this is the correct forum, but here it goes.
I have a Sanke keg that I would like to convert to a mash tun w/ RIMS.
I was curious if anyone in Denver/Boulder/Ft Collins/Springs is capable of doing this? Or, if you have had it done, where did you go? What was/would be the cost of doing this?
The closer to Boulder the better!
TIA
Dave