orangehero
Well-Known Member
Hello,
This is a mash tun made from a plastic covered 50L keg.
The top has been removed and a bottom drain has been soldered in. The bottom drain consists of a 1/2" SS female elbow and 1/2" x 8" SS nipple. The photos show a 3-piece valve, but I'm going to keep it. Instead there will just be a 1/2" SS two-piece valve so you can put whatever connector or fitting you want on the end.
1/4" SS half-coupling soldered into the side to accept an RTD probe. It can be easily plugged for use without a thermometer.
Custom wrap made of reflectix consisting of three pieces: a wrap for the outside and covers for the lid and bottom.
Glass lid and a custom 15" 16-gauge SS hinged false bottom with handle. The handle is placed next to the hinge to make it easier to pull the false bottom up through the grain once you're finished mashing.
Not pictured is a nylon strap used to secure the insulation that I will include as well.
Everything is in excellent, lightly used condition. The mash tun will hold mash temp for over an hour.
$275 for everything.
Located near Hartford, CT. I'd prefer to sell local but I'll consider shipping for an extra fee...probably $30-40.
Thanks for looking!
This is a mash tun made from a plastic covered 50L keg.
The top has been removed and a bottom drain has been soldered in. The bottom drain consists of a 1/2" SS female elbow and 1/2" x 8" SS nipple. The photos show a 3-piece valve, but I'm going to keep it. Instead there will just be a 1/2" SS two-piece valve so you can put whatever connector or fitting you want on the end.
1/4" SS half-coupling soldered into the side to accept an RTD probe. It can be easily plugged for use without a thermometer.
Custom wrap made of reflectix consisting of three pieces: a wrap for the outside and covers for the lid and bottom.
Glass lid and a custom 15" 16-gauge SS hinged false bottom with handle. The handle is placed next to the hinge to make it easier to pull the false bottom up through the grain once you're finished mashing.
Not pictured is a nylon strap used to secure the insulation that I will include as well.
Everything is in excellent, lightly used condition. The mash tun will hold mash temp for over an hour.
$275 for everything.
Located near Hartford, CT. I'd prefer to sell local but I'll consider shipping for an extra fee...probably $30-40.
Thanks for looking!