thedude123
Well-Known Member
Does anyone know how to make a stir plate?
Does anyone know how to make a stir plate?
A quick aside.......
How long do you leave it on for a starter? 24 hours a day?
That is the tits.Don't even try, it can't be done. Totally impossible!
![]()
Ya I found that thread after I had already posted this thread. After looking at that thread I think it might just be easier for me to buy one. Yuri would be the guy to ask you say.
What is a 5v wall wort? I don't care what it looks like I just want it to work.
assuming the voltage and amps were okay. It should say that on the wall wort.So if I had an old cell phone charge and cut off the end piece that goes into the phone then connected the wires to the fan, I would be all set?
Could you compensate for the fan spinning too fast by placing the flask slightly further away from the magnet? Say, by putting a magazine in between the flask and the stirplate?When I used a 9V power supply the fan was spinning way too fast, would pull air to the bottom in a 1 gallon glass jug with a gallon of water. The 5V spins it perfectly.
Could you compensate for the fan spinning too fast by placing the flask slightly further away from the magnet? Say, by putting a magazine in between the flask and the stirplate?
I have no idea whether that would improve things or add a new layer of wrongness.
So if I had an old cell phone charge and cut off the end piece that goes into the phone then connected the wires to the fan, I would be all set?
Enter your email address to join: