Is it terribly difficult to drill a hole through a stainless pot? I got a new 10 gallon BK, and was planning on mounting a spigot/ball valve on the side. I went to Ace, and they had those drill bits for drilling through metal.
Is there any trick to it, or is it just like drilling though a piece of wood. I know you kind of need a pilot hole before you make your for real hole.
It's probably a stupid question, but I'd rather ask it and look like a muppet, than screw up a new stainless pot. They are not cheap.
Is there any trick to it, or is it just like drilling though a piece of wood. I know you kind of need a pilot hole before you make your for real hole.
It's probably a stupid question, but I'd rather ask it and look like a muppet, than screw up a new stainless pot. They are not cheap.