Ok so after a few dip tube designs that worked ok.. i thought why not just used 1/2 copper with fittings
I noticed that i can get the fittings to stay together relatively well by putting a wrap of teflon tape around the slip fittings. Certainly well enough to do a brew but then when you take it apart to clean everything you have to redo it everytime.
Aside from lead solder is there any good way to join the pipe to make this option work? Any thoughts??
I noticed that i can get the fittings to stay together relatively well by putting a wrap of teflon tape around the slip fittings. Certainly well enough to do a brew but then when you take it apart to clean everything you have to redo it everytime.
Aside from lead solder is there any good way to join the pipe to make this option work? Any thoughts??