I just started kegging and am concerned that I may have a co2 leak. 2 weeks ago I put my first keg into my kegerator and the regulator was reading just over/at the 600 psi line, or above the red. I keep my regular/co2 tank inside my kegerator. Pressure remained constant for the first keg. I added a second keg to the system 5 days ago and for the first couple of days it appearted the pressure was also pretty much constant. I checked it yesterday and it had dropped below the red line and I checked again today and it's after dropping a little more, now at about 425. My fridge temperature is at 41 degrees.
To carb my kegs I put them at 30 psi for 24 hours and then back to serving at around 10-11psi. I would guestimate I have gone through about 1/3 to 1/2 of the first keg and about 6 glasses out of the second. The only other co2 I used would have been to seal and purge the kegs after I sealed them.
Here's a picture where my regulator pressure is now. Should I be worried?
[IMG="http://www.flickr.com/photos/92283963@N03/8387153433/"]
To carb my kegs I put them at 30 psi for 24 hours and then back to serving at around 10-11psi. I would guestimate I have gone through about 1/3 to 1/2 of the first keg and about 6 glasses out of the second. The only other co2 I used would have been to seal and purge the kegs after I sealed them.
Here's a picture where my regulator pressure is now. Should I be worried?
[IMG="http://www.flickr.com/photos/92283963@N03/8387153433/"]