Primevci
Well-Known Member
On this setup? if you had $1050 to spend?
Two Tier stand- HLT Sits higher and Gravity feeds into MLT. MLT and boil kettle on same level. Stand is MIG welded Square tube steel painted black with high heat paint. It can break down into 2 pieces for easier transport. Stand has 2 Banjo Burners attached. Locking heavy duty casters for easy moving.
Kettles are converted Kegs, all have weldless 3 piece ball valves and fittings. All keggles have stainless steel camlock quick disconnects. Dip tubes and other specifics noted below.
Hot Liquor Tank (HLT)- Converted Keg, lightly polished. Has polycarbonate sight tube and weldless thermometer attached. ½ Inch Copper Dip tube.
Mash/Lauter Tun (MLT)- Converted Keg, insulation attached, 3/8 inch Stainless dip tube with Brass Compression Fitting connects to Sanke Contoured False bottom. Aluminum lid with CPVC sparge system attached. Weldless thermometer attached.
Boil Kettle- Converted Keg lightly polished. Copper Dip tube. PVC/CPVC Hop spider with nylon bag.
Hoses- Three ½ inch hoses with stainless quick disconnects on each end.
Burners- Banjo burners, comes with 2 high pressure regulators, an 10psi and a 30psi.
Counter Flow Chiller (CFC)- Very High efficiency 25 foot long CFC, 3/8 copper, brass hose fittings, quick disconnect on one side closest to kettle.
Pump- Chugger Pump Poly Inline. Stainless steel 2 piece Ball valve and quick disconnects on both sides. It bolts on to lower part of stand.
Two Tier stand- HLT Sits higher and Gravity feeds into MLT. MLT and boil kettle on same level. Stand is MIG welded Square tube steel painted black with high heat paint. It can break down into 2 pieces for easier transport. Stand has 2 Banjo Burners attached. Locking heavy duty casters for easy moving.
Kettles are converted Kegs, all have weldless 3 piece ball valves and fittings. All keggles have stainless steel camlock quick disconnects. Dip tubes and other specifics noted below.
Hot Liquor Tank (HLT)- Converted Keg, lightly polished. Has polycarbonate sight tube and weldless thermometer attached. ½ Inch Copper Dip tube.
Mash/Lauter Tun (MLT)- Converted Keg, insulation attached, 3/8 inch Stainless dip tube with Brass Compression Fitting connects to Sanke Contoured False bottom. Aluminum lid with CPVC sparge system attached. Weldless thermometer attached.
Boil Kettle- Converted Keg lightly polished. Copper Dip tube. PVC/CPVC Hop spider with nylon bag.
Hoses- Three ½ inch hoses with stainless quick disconnects on each end.
Burners- Banjo burners, comes with 2 high pressure regulators, an 10psi and a 30psi.
Counter Flow Chiller (CFC)- Very High efficiency 25 foot long CFC, 3/8 copper, brass hose fittings, quick disconnect on one side closest to kettle.
Pump- Chugger Pump Poly Inline. Stainless steel 2 piece Ball valve and quick disconnects on both sides. It bolts on to lower part of stand.