EarthBound
Well-Known Member
I'm installing a heating element into my keggle, and I used a 1.25" conduit punch! The hole diameter is 1.6875". I'm not sure exactly what to do to fix this.
I was thinking of JBwelding the SS washer (1.5" ID, 2.25" OD) onto the kettle wall. The problem with that idea is that the washer is flat against the convex kettle wall. Maybe I should TIG weld the washer onto the kettle wall?
I was thinking of JBwelding the SS washer (1.5" ID, 2.25" OD) onto the kettle wall. The problem with that idea is that the washer is flat against the convex kettle wall. Maybe I should TIG weld the washer onto the kettle wall?