regulatedhobbyist
Well-Known Member
So, I went to the LHBS and purchased a glass 1 gallon growler a couple weeks ago. I found out last night that the mouth on this particular growler is about 1/8th of an inch too small for both my wine thief and my auto siphon. The bottom piece of both tools are soft(ish) plastic. I was thinking maybe I could sand them down. The guy at another LHBS suggested using a heat gun and stretching the mouth of the growler, but I don't have one.
Racking of one batch is due, any suggestions?
Racking of one batch is due, any suggestions?