Here is the parts list.
Bimba cylinder SS-316-DXPW
From McMaster
7768k22 check valve
7768k26 check valve
5272k201 compression fitting
89895k121 ss tubing
Carr Lane Manufacturing
CL-150-TPC-S toggle clamp
I had to drill and tap another hole in the bottom of the cylinder for a check valve, installed both check valves, one for beer in, one for beer out. Bent the tubing to make a nice swan neck, attached to the out check valve with the compression fitting. The other check valve gets a barbed fitting to match the beer line. The frame was some scrap 1.5 inch angle iron welded together to make a c channel, next one will have nice SS c channel bought. The toggle clamp was welded to the cylinder shaft and a 3/8 nut welded to the back side to allow for mounting on the bracket. All in all, took about an hour to build.