purplehaze
Well-Known Member
- Joined
- Mar 2, 2011
- Messages
- 398
- Reaction score
- 27
I recently finished my single tier rig and made a couple of March pump splash shields out of aluminum diamond plate. Unfortunately the mounting tabs were bent the wrong way.
So I have two smooth exterior March 809 pump shields for sale $25 each shipped or both for $45 shipped. If your looking to trade I am interested in:
-false bottom for 10 gallon rubbermaid cooler.
-perlick fausets
-pin lock corney kegs
The diamond plate is approximately 1/8” thick X 4 3/8” tall X 4 ¾” wide X 8” long.
Since every installation is different you will have to drill mounting holes on the flange as well as drill a hole for the power cord. My pump had a plug on the power cord so the easiest way for me to mount it was to cut a slot. See pic below. Any questions feel free to pm me.
So I have two smooth exterior March 809 pump shields for sale $25 each shipped or both for $45 shipped. If your looking to trade I am interested in:
-false bottom for 10 gallon rubbermaid cooler.
-perlick fausets
-pin lock corney kegs
The diamond plate is approximately 1/8” thick X 4 3/8” tall X 4 ¾” wide X 8” long.
Since every installation is different you will have to drill mounting holes on the flange as well as drill a hole for the power cord. My pump had a plug on the power cord so the easiest way for me to mount it was to cut a slot. See pic below. Any questions feel free to pm me.