BasementGrowler
Member
I just picked up a 40 gallon 2/3 steam jacketed kettle that the furnace went bad on. Plan on stripping all un needed parts off it and cut the steam chamber off. Hopefully I will be left with a 40 gallon brew kettle. It has a 2" tangent valve toward the bottom. Anyone have any ideas how to reduce the 1 1/2" pipe, that the valve assembly is attached to, down to around 1/2". The valve is not on the kettle so I can't use it, only the valve "housing" is attached to the kettle.
I own a steel fab shop so stainless steel welding/fabrication is not an issue.
I own a steel fab shop so stainless steel welding/fabrication is not an issue.