I've been following Kal's great plans over at theelectricbrewery.com, and am in the process of wiring my control panel.
I am using an Auberins ASL-51 timer, and after reading the terminal assignments in the manual and attempting to compare it to the diagram in the instruction manual for the Omega PTC-21 that Kal is using, I am not certain as to how to wire this to meet my goal.
The goal in wiring the timer is to have a normally open contact block connected to a reset button that would start the timer countdown over. I also have alarm switches for each PID and the timer itself. The idea is to wire this to have the same results as outlined on Kal's build here.
Here is the terminal assignment diagram for the ASL-51:
Here is the diagram for the PTC-21:
How can I translate Kal's wiring for the PTC-21 to the ASL-51?
Thank you in advance.
Rob
I am using an Auberins ASL-51 timer, and after reading the terminal assignments in the manual and attempting to compare it to the diagram in the instruction manual for the Omega PTC-21 that Kal is using, I am not certain as to how to wire this to meet my goal.
The goal in wiring the timer is to have a normally open contact block connected to a reset button that would start the timer countdown over. I also have alarm switches for each PID and the timer itself. The idea is to wire this to have the same results as outlined on Kal's build here.
Here is the terminal assignment diagram for the ASL-51:
Here is the diagram for the PTC-21:
How can I translate Kal's wiring for the PTC-21 to the ASL-51?
Thank you in advance.
Rob