yeastbound
Active Member
Hey guys,
My father-in-law is a welder, and has agreed to build me a brew stand. All I have to pony up for is the materials. I was inspired by Terapin Chef's rig, and worked this design up in Google Sketchup:
Can I get an extra set (or two, or three) or eyes on this and:
1. Make sure my math is sound and
2. Offer any advice on the design.
Chef's rig is made out of 8 gauge 2" square pipe. To keep the cost (and weight) down, I wanted to go with 11 gauge 1" square pipe. FIL says that structurally I'll be OK with the smaller pipe.
Any comments, ideas, suggestions? Thanks in advance!!
My father-in-law is a welder, and has agreed to build me a brew stand. All I have to pony up for is the materials. I was inspired by Terapin Chef's rig, and worked this design up in Google Sketchup:
Can I get an extra set (or two, or three) or eyes on this and:
1. Make sure my math is sound and
2. Offer any advice on the design.
Chef's rig is made out of 8 gauge 2" square pipe. To keep the cost (and weight) down, I wanted to go with 11 gauge 1" square pipe. FIL says that structurally I'll be OK with the smaller pipe.
Any comments, ideas, suggestions? Thanks in advance!!