InYerMouth
Well-Known Member
I went with a figure 8 copper manifold and used a dremel to saw slits in the bottom side of the manifold...to make it even easier, I didnt solder anything together, just used t-connectors and elbows...works great, saved time on construction and very easy to take apart and clean...dont see the need to solder...if it fits together. I put holes in the bottom anyway. the point is to allow liquid through it anyway right?? No problems yet but then again I am still a noob...lol.
One question I do have just in case is with the rice hulls...I am getting ready to do a hefe and an oatmeal stout and know I should use them...does it matter where in the mash I add them?? on bottom, on top...or mixed in?? does it matter?
One question I do have just in case is with the rice hulls...I am getting ready to do a hefe and an oatmeal stout and know I should use them...does it matter where in the mash I add them?? on bottom, on top...or mixed in?? does it matter?