grassafrass
Member
I have several 1/2 barrel kegs lying around, and I want to try to convert one into a corneluis keg. They are almost the same height as a corny keg, so I think the dip tube should work, and the in/out posts shouldn't be a problem.
As for the lid... there is no way I can fabricate the lip that the lids o-ring seats against, so I will most likely rob the entire top off of a cornelius keg and weld that into the 1/2 barrel keg top using a sanitary weld. Does this sound feasible?
I would love to know if this has been done/tried before, and any suggestions or tips would be greatly appreciated.
Thanks.
As for the lid... there is no way I can fabricate the lip that the lids o-ring seats against, so I will most likely rob the entire top off of a cornelius keg and weld that into the 1/2 barrel keg top using a sanitary weld. Does this sound feasible?
I would love to know if this has been done/tried before, and any suggestions or tips would be greatly appreciated.
Thanks.