Search results

I'm in!

I'm In!

I'm in!

I just wanted to give a shout out to stainlessbrewing.com After the craptastic job I did with a pipe bender to make a Herms coil out of stainless steel, I wish I would have paid the $20 more to get it premade from Zach the first time around. Once my HLT is built I'll post pictures and...

I'm in!

Reply!

It seems no one has brought up the question about needing an electrical cord where the sheathing can handle 100C. Does anyone know what the internal temperature of the heat stick tube gets to?

:tank:

It's kind of like food. I refuse to tell people what's in my Sunday dinner until after they have eaten. You will always get buttheads that their momma didn't raise them right. Eventually you will get to a point where people will trust your pallet and when you say hey try this, they will.

It was a pretty straight forward build. A couple of notes... -used a small chisel to break the tabs securing the top to the front -did not reuse the housing for the temperature gauge / door light -soldered the connection closed for the door switch light and filled the hole with GreatStuff foam...

These are not kept in stock at my local homebrew store and I was brewing that weekend. The Teflon encapsulated o-rings where fine, it was the others that needed replacing. The #47 & #7 o-rings are readily available at Lowes or HomeDepot. The #206 was lower priority, so I ordered it online.

I recently purchased 2 used Better Bottles with the spigots and all of the rubber o-rings needed to be replaced. I did a search on here and came up empty. So, to save others the frustration of figuring out what is needed, here is what I used. #206 - For the plug on the cap #47 - The 2...

pick me!