Search results

Hey, where are you located in Georgia? I'm out in Carrollton, if you're close you can have as many bottles as you need from me!

Thanks guys! I'll post a pic in just a bit, but I am using a rubber gasket that came with the bulkhead kit, not a rubber o-ring. For the element I will use one, but on the ball valves it's just an orange/brownish rubber gasket.

yeah we did tighten it with a wrench. Should we only hand tighten them? and Slakwhere: I read that the soldered fittings weren't a good way to go because of the heating then cooling constantly can lead to the solder cracking.

I want to say it was 1 1/4". However big it was the threads fit snugly in the hole so you almost have to thread it in the keg.

Yes I do! I went per directions of a few of the posts on here and got the bulkheads and o-rings from bargain fittings. http://www.bargainfittings.com/index.php?route=product/product&product_id=167

Hey guys, my friends and I are doing our first electric brew setup and we have all the parts we need thanks to all of the posts on here. We have the holes drilled and want to put the heating element in without welding and are having problems keeping it water tight. Any tips would be super...

We're just getting a electric brew system setup and I am using an Arduino microcontroller and a SSR to get things going and so far it works well.