Search results

SSBrew - 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    Electrical short in control panel!

    Ok so I'm gonna try to describe this as best as I can and hopefully someone can shine some light on this mystery. Systam setup: I've attached the schematic of the wiring system I am using. Basically the whole unit is wired like so: 4 Prong dryer outlet > 50amp Spa Panel > Control Panel >...
  2. A

    5500W Heat Element to LED

    Hey Everyone, So I am wiring up my new setup which will be wired using the diagram below. Instead of a PID I will be using a PWM. I would like the LED (that I added to the following diagram to come on at the same time as power is sent to the element. Is this the best way to wire it?
  3. A

    Contactor question for single element BIAB

    Hey, Just wondering if anyone had any input on whether this contactor would work for a 240v 5500w element: http://www.amazon.com/Packard-C230B-Pole-Contactor-Volt/dp/B001KGSJ74/ref=sr_1_1?s=hi&ie=UTF8&qid=1359495429&sr=1-1&keywords=contactor+240v-30A+120V+COIL I'm just a bit thrown off by...
  4. A

    Hop Filter Bags

    I came across a DIY for a hop spider last year and decided to build one. The suggested hop screen for the filter of the hop spider is a paint strainer bag. However, I came across these this weekend (see attached picture) and was wondering if anybody had some insight on wether these could handle...
  5. A

    Kegerator is always dispensing foam, HELP!

    I bought a new kegerator at a local store recently and everynow and then it will just completely turn the beer to foam when pouring. I've checked for ice in the lines it's not that. The pressure is set to 10 psi so it should be good. Temperature of the fride is set to 3 (out of 10). I've tried...
  6. A

    Weldless Fittings For 1/4" Thick Kettle

    So I just ordered an 80 qt aluminum stock pot for brewing and planned on converting it into a brew kettle. I noticed the stock pot has about a 1/4" wall thickness and realized that this would be a problem for normal weldless bulkhead fitting. I was wondering if anyone had any information for...
  7. A

    Burner Setup For New Brewstand Design

    Hey all, I was just looking at getting some information regarding the setup of my burners for my brewstand. My setup will consist of 3 low pressure 70,000 BTU burners that can be found here : http://www.agrisupply.com/burner-cast-low-presure-multi-hole-/p/40282/cn/5400000/ My question is...
Back
Top