Search results

@planker101, what are you using for the spinning mechanism of your pulley arm?

In!

Congrats!

In!

In, thanks!

I'm in. Thanks SS Brewtech!

In!

In!

I'm in!

In!

Thanks for the info everyone. Went ahead and purchased the brew bucket and racking arm separate. :ban:

Does anyone know of a vendor who has the brew bucket with the longer racking arm?

Awesome; I'm in!

Does anyone have the 20L? If so, what is the total volume for that one? It looks like the 30L is marketed a 7.9, but it sounds like it can hold upwards of 9 gallons

For the Speidel 20L, I know it says 5.3 gallons, but how much total volume do you think it will hold. I can't quite fit the 30L in my ferm chamber, but if the 20L is around 6.5 gallons like my carboy I don't think it will be an issue for fermentation.

I'm trying to figure out if the 30L will fit in my ferm fridge or not. I'm good on the height, but I'm a little fuzzy on the width. It says the width is approx 13.5", but I don't know if that is the bottom measurement or what. It looks like bulges our a bit and then the handles add width as...

wilconrad, what was the temp of the water you were running through it?

I'm in!

I have the same style of keg and I used a weldless bulkhead with a stainless elbow and a hose barb attached to it. It picks up from the side and it doesn't leave much wort behind. It is really close to the side so it doesn't interfere with my wort chiller either.

Hi, I'm looking to purchase this kettle from MoreBeer http://morebeer.com/products/heavy-duty-brew-kettle-ball-valve-notched-lid-60-quart15-gallon.html I'm wanting to put a recirc tube in the temp coupler, but I need some sort of compression fitting that allows me to connect a ball valve...