Search results

I'm putting together a pulley system for my grain mill and the larger pulley I have requires a bushing to connect to the mill's shaft. Do you think this split bushing would slip on the rollers or should it power it just fine?

I'm planning on brewing today. I noticed these bulb like things coming up from within the yeast layer. There doesn't seem to be any sour or off smells in the starter, but I'm not looking to ruin my iipa today either. :) After they hang at the top for a minute they fall back down and by then a...

When I went to all grain I bought a 20 gallon pot that is about 18" wide at its base. I currently have a burner very similar to the SP10 (jet burner). It can easily handle heating the water and boiling the brews, but obviously the rolling boil only happens at the very center of the pot where the...

So I wasn't able to find a direct answer to this question so I thought I'd ask. I know you can boil off liquids under vacuum at room temperature if you apply enough of a vacuum, as well as remove the CO2 from the wine. I was curious if the Vacu Vin could generate enough of a vacuum to pull out...

So it appears now is the time to take the plunge into all grain brewing judging by the forums. Count me in as one of the many. Like most my first one didn't go exactly perfect by any means, but at the end I hit my SG and was only slightly over my volume without adding any light DME. So that was...

I'm on my third batch of beer and I thought I read to add all the DME and the 1/2 gallon LME after steeping the grains. However I was supposed to only add the LME with 15 minutes left on the clock during the hops boil. Will adding the LME earlier in the process yield dramatically different...