Search results

Doug, Still getting the debug and also issue with git pull on xml_branch

Doug, Did the Pull and all works in Chrome. I changed the timer back to Mash and Boil and it started right up. Great Job. But getting this now in the ssh console:

Doug, So I changed the config file from: <timer id="Mash"/> and <timer id="Boil"/> To: <timer id="mash"/> and <timer id="boil"/> And it worked.

No error message. I'm looking at everything but can't figure this out. I thought it worked before but had other issues when you first started the xml branch. Edit: I hit Reset Mash and everything comes back to normal.

This is what I have when I change over to xml_branch;

This is what I have:

{"brewday":{"mashStart":"2014-01-28 15:47:11 -0500"},"kettle":{"elapsed":1390942043612,"scale":"F","temp":65.975},"mlt":{"elapsed":1390942043858,"scale":"F","cycle":0.0,"d":0.0,"duty":100.0,"status":"off","p":40.0,"temp":67.325,"gpio":"GPIO11","setpoint":175.0,"mode":"off","i":0.0},"fermentation...

Doug, I switch back to the master branch and use my old config and the timer works fine.

Ok, I cleared out my cache and reset the browsers. I just get this now. event.returnValue is deprecated. Please use the standard event.preventDefault() instead.

Here is what I get for Javascript: XMLHttpRequest cannot load http://54.225.157.207/api/ping?format=jsonp&key=09695a140f3e3733bf0bb99d4a6…2F%2F192.168.0.63%3A3131%2Fcontroller&v=1&jsonp=vglnk_jsonp_13909288645915. No 'Access-Control-Allow-Origin' header is present on the requested resource...

{"brewday":{"mash":{"start":"2014-01-28 09:37:18 -0500","end":"2014-01-28 09:37:17...

This is what happens when I start the timers and refresh the web browser. They still are grayed out. Sometimes the bottom timer will work, but then this happens. I did not get any errors on the server.

Doug, Do you know why I keep getting these errors when shutdown the server:

Also, the timers gray out once you click on them to start. Tried FireFox and Chrome Browsers:

OK, Now I changed the one pump to MLT_Pump and left the other alone, but get 4 pumps on the webpage:

Doug, I changed my naming of the pumps so they didn't have 2 words. I changed "HERM Pump" to pump1 and "MLT Pump" to pump2 and it saved the config to xml.

Doug, I'm getting this error when shutting down.

Doug, I ran the server with the --config switch and everything worked the first time, but when I stopped the server and it rewrote the config to XML it removed my Pumps. I took out the owfs in the general section too.

I think I'm going to try not using the owfs for now. Do I just remove it from the general section of the config and change the probe addresses back to the w1

I see now that the Address for the OWFS are different them the old 1wire with the 28-XXXX then the 28.XXXX So I will change the addresses in the config file to match the addresses on the OWFS directory.