Search results

Is there an easy solution for this. I have a 3 tap beer tower & I would like to use decorative tap handles such as those in the picture, but unfortunately they hit each other. I could angle the ones on the outside, but I think that would look weird. One solution I can think of is to extend...

Just getting my Keezer setup. Started off with a lot of foam, seems to be getting better but still room for improvement. Should this air/co2 gap be in tube beer line? If not what’s causing it? Co2 pressure set to 11 psi or so.

I decided to opt for a 10lb CO2 tank which just about fits on the shelf of my keezer, completely forgetting to allow for space for the extra height of the regulator. I assume I could just get an angled connector to put between the tank and regulator. Any better solutions? I assume I would just...

There are way too many options when it comes to regulators. This is my first Keezer build & I'm building a 3 tap system. My gut is sending me in the direction of a micromatic regulator - Primary Double Gauge - CO2 Is this a good solid regulator or should I be considering something else...

Ok this is my first Keezer build. My plan is to build a Keezer without a collar and have a beer tower instead and cut a hole in the freezer lid for the tower. I’m considering this 3” tower: Polished Stainless Steel Triple Faucet Draft Tower - 14" Tall - 3" Diameter Column - Perlick Faucets |...

I'm looking for a Kegerator or Keezer to ideally hold 3, 5 gallon kegs. This needs to fit under a bar counter which is 40" from the under side of the bar to the floor. I would like to install a tower in the bar counter. I would consider making something from a Fridge/Freezer or buying a complete...