Search results

btt

I could pull off 15 gallons if it was a 60 min boil.... I started to craft 12 gallon batches with a 90 min boil.. it requires a 30 amp circuit (same as an electric dryer I believe)...

I don't remember selling a kegging system, but anything's possible... I'm in Palm Harbor if that rings any bells for you.

Absolutely, it holds a full Boil Kettle at full-boil!!! If you have never had experience with 80/20 Extrusions and the fasteners, then you are missing out! I have run 50-60 Batches on this system and it is rock solid.

Make your own award winning beer!!! Local Pickup ONLY.... Palm Harbor, FL I AM NOT PARTING OUT THE SYSTEM, SO PLEASE DON'T ASK Three-Tier HomeBrew Brewery System - All Grain HERMS Systems (Heat Exchanger Re-Circulating Mash) 15 Gallon Nano-Brewery Engineered from modular 80/20 aluminum...

As much force as I can put on a decent size craftman wrench. I haven't used any mechanical advantage yet... It doesn't make sense that it is this difficult.

After testing my new Stainless HERMS HLT, I noticed a leak coming from the compression fitting. After removing the compression nut, I decided to back out the whole fitting from the S/S coupling that was welded in. It turned about 1/4 to 1/2 turn and instead of getting easier, it got tougher...

I have several dozen batches under my belt w/ my Blichmann... here are my suggestions. 1) Tear it down between batches including fittings and valves. Never assume it is clean enough w/ Star San. 2) If you are using an aggressive yeast strain, tighten down the lid lock past finger tight...

Official backer too

PM sent.

Will sell for $40 shipped

BTT... .still for sale

Brand new Hopblocker, comes in original box with O&M manual. never used. $40 plus shipping USPS

I am unsure of the ethics (or board rules) behind asking around for someone to share a slant of a banked yeast strain (especially when we are talking about VSS strains). Is there a good place where you can get some of the previously released strains (or a Yeast Swap, Yeast Pass)?