Search results

Any idea where to purchase Rasberry Pi ? The seem to be hard to come by.

I have opened the fermentation chamber door and have both ipad and samsung phone within a foot of conical and get nothing. It would be one this if it were one Tilt but its both of them doing the same thing should eliminate dead batteries. These both worked just minutes before in water on kitchen...

I recently purchased two version 3 Tilt Hydrometers. After reading numerous posts, I thought these could be used in my Spike CF10 conical fermenter. They worked fine when testing them in a glass of tap water in my kitchen. I was able to read them both using the Tilt 2 app. I dropped both Tilts...

I have a Haier kegerator and want to control with my Inkbird 308. I need help on how to bypass the Haier thermostat. Any help will be appreciated. Thanks !

Nice setup. Where did you get the spreader bar to lift the Spike basket ?

I've tried heating the joints with Mapp gas with no luck. It doesn't appear that it's getting hot enough. The Tee is out of round where the copper 90 enters into it. Once I was to get it apart, I'd planned on silver soldering it back together. I appreciate the response.

I have a copper counterflow chiller that was dropped and it bent the 1/2” 90 as well as the 3/4 to 1/2 to 1/2 copper fitting. It appears the inner copper copper coil is soft copper which is smaller than 1/2“ in diameter. It appears it was brazed rather than soldered.Any ideas on who to go to to...

Depending on cost and shipping, I’d be interested in the I’m interested in your CF10 jacket. Do you have photo and cost plus shipping to 32176 ? Thanks

I just purchased a Spike Conical CF10 and would like to buy - 1. Temp Control Coil 2. Conical jacket 3 Short Leg Extensions 4. Conical Heater

I live in central Florida and I'm interested in buying a good quality conical fermenter. Preferably a Spike CF10. Thanks !

Sorry for the typo. The water boiled when my EZ boil was reading 182. I also checked the Pb offset and it was set to 0.0. I already sent Auber an email but haven't heard back yet. I'll update what I find out. Thanks

I’ve checked the cable for continuity at both ends of I have checked the probe connections and they are making good contact. I also checked for continuity and all is good. I took your advice and checked PT-100 probe as well three other pt-100 probes in the ice bath they all read the same 6...

I am using an AUBER Cube 2E with the EZ Boil DSPR320 with four inch PT-100 temperature probe and 20 gallon Spike Solo with basket. When in boil mode, the temperature reading at full boil on the EZ boil reads 82 degrees. Any thought as to why there would be a thirty degree temperature...